Low power, high torque motors where the housing is made in titanium for long time deployments. The motor is oil filled and pressure compensated, and has been tested down to 650 bar. The motor was originally designed for use in systems where power is supplied from battery banks.
Several models are available with different power, torque and speed. All models are brushless servomotors, with different gear ratio.
To reduce risk of noise interference to sensitive echo sounders and other sensitive sensors close by, the motor controller is placed inside the motor Only DC power and a RS232 control signal are present in the motor cable.
This motor is delivered with a standard depth rate of 150 Bar, but is also available in D version rated at 600 Bar.
More details
DSM 500C
Technical Specifications
Size: 70 x l83mm (d x l)
Material: Titanium GR2
Depth rate: 150 Bar
Power: 12 Volt
Interface: RS232
Connector: Imenco Metas MB2S-8
Torque: See table below
Speed: See table below
Weight: 2,1 kg
In water: 1,3 kg
Options
- Depth rate = 600 Bar
- Several other types of Motors are available according to torque and RPM requirements
- All Motors are available in 24, or 48 volt versions upon request. Max current for these motors is 50-75% lower than the 12 volt version.
- Software for different applications
DSM 600
Technical Specifications
Size: 85 x 268 mm (dx /)
Material: Titanium GR2
Depth rate: 600Bar
Power: 12 Volt
Interface: RS232
Connector: Imenco Metas MB2S-8
Torque: See table below
Speed: See table below
Weight: 3,8 kg
In water: 3,1 kg
Options
- Several types of motors are available according to torque and RP1 requirements
- All motors are available in 24, or 48 volt versions upon request. Max current for these motors is 50-75% lower than the 12 volt version
- Software for different applications
Contact
