Imenco AS

SFC SPM Loading Buoy Removal

Imenco AS was approached to design and fabricate a 20” Blind Flange Nut Carrier system and a Blind Flange with ROV interface. Positioning and assembly of the blind flange was to be performed subsea by ROV. As part of the testing process, 5 separate Factory Acceptance Tests (FAT) where carried out to verify the performance of the system. Challenges for this project included the angle at which the flange was to be positioned at as well as correct locating of all the flange bolts. Feedback during testing (which was supported by the ROV pilot was that the system was simple and affective. The installation was performed without incident and all parties where satisfied with the end result.

Engineering & Development

Latest news

Faudi AFGUARD Now accepted by JIG

With reference to JIG Bulletin no. 110 "Use of Electronic Water Sensors", Imenco are pleased to announce that the FAUDI Aviation electronic water sensor is qualified as an alternative to chemical water detectors. The AFGUARD® is the only electronic sensor commercially available to monitor the amount of wate... Read more »

Imenco Bauer Hydraulics and Diinef Launch Digital Motor

Imenco Bauer Hydraulics and Diinef launch the worlds first High Torque Low Speed digital motor on Nor-Shipping in Oslo, May 30’th to June 2’nd. Read more »